AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Genie idrive garage door opener dayton12/7/2023 The data flow diagram above explains how the three pieces of software (Arduino, Mosquitto, and OpenHAB) work together to get the functionality we're after. It won't work because the batteries aren't installed. Once the wires are installed, try to open garage by touching the two wires together. If you measure the continuity across the two wires, it should be an open circuit. You should take the batteries out of the remote so you don't accidentally operate the garage door. Solder a few inches of wire to these two legs. Use a multimeter to determine which two pads/legs on the button are shorted when the button is pressed. Next, decide which button corresponds to the garage door open button. Here's the circuit board removed from the remote housing. This following series of pictures should give you a good idea of what to do. First, remove the circuit board and solder wires to one of the buttons. To do this, we need to prepare the remote. Next, we'll be using the relay module to actuate the button on the spare garage door remote. Once you have the parts, assemble the Arduino components (Arduino, ethernet shield, prototype shield) into a stack like this. I've combined these tasks into this step. The initial hardware preparation involves putting the Arduino together and getting the garage door remote ready for wiring.
0 Comments
Read More
Leave a Reply. |